[April-2021]Valid NSE7_SDW-6.4 Exam VCE and PDF Dumps Free Download in Braindump2go[Q11-Q27]

April/2021 Latest Braindump2go NSE7_SDW-6.4 Exam Dumps with PDF and VCE Free Updated Today! Following are some new NSE7_SDW-6.4 Real Exam Questions!

QUESTION 11
Which components make up the secure SD-WAN solution?

A. FortiGate, FortiManager, FortiAnalyzer, and FortiDeploy
B. Application, antivirus, and URL, and SSL inspection
C. Datacenter, branch offices, and public cloud
D. Telephone, ISDN, and telecom network

Correct Answer: A

QUESTION 12
Refer to the exhibit.

Which two statements about the status of the VPN tunnel are true? (Choose two.)

A. There are separate virtual interfaces for each dial-up client.
B. VPN static routes are prevented from populating the FortiGate routing table.
C. FortiGate created a single IPsec virtual interface that is shared by all clients.
D. 100.64.3.1 is one of the remote IP address that comes through index interface 1.

Correct Answer: CD

QUESTION 13
Refer to exhibits.

Exhibit A shows the SD-WAN rules and exhibit B shows the traffic logs. The SD-WAN traffic logs reflect how FortiGate processed traffic.

Which two statements about how the configured SD-WAN rules are processing traffic are true? (Choose two.)

A. The implicit rule overrides all other rules because parameters widely cover sources and destinations.
B. SD-WAN rules are evaluated in the same way as firewall policies: from top to bottom.
C. The All_Access_Rules rule load balances Vimeo application traffic among SD-WAN member interfaces.
D. The initial session of an application goes through a learning phase in order to apply the correct rule.

Correct Answer: AB

QUESTION 14
What are the two minimum configuration requirements for an outgoing interface to be selected once the SD-WAN logical interface is enabled? (Choose two.)

A. Specify outgoing interface routing cost.
B. Configure SD-WAN rules interface preference.
C. Select SD-WAN balancing strategy.
D. Specify incoming interfaces in SD-WAN rules.

Correct Answer: AB

QUESTION 15
Refer to the exhibit.

Based on the exhibit, which statement about FortiGate re-evaluating traffic is true?

A. The type of traffic defined and allowed on firewall policy ID 1 is UDP.
B. Changes have been made on firewall policy ID 1 on FortiGate.
C. Firewall policy ID 1 has source NAT disabled.
D. FortiGate has terminated the session after a change on policy ID 1.

Correct Answer: B

QUESTION 16
What are two reasons why FortiGate would be unable to complete the zero-touch provisioning process? (Choose two.)

A. The FortiGate cloud key has not been added to the FortiGate cloud portal.
B. FortiDeploy has connected with FortiGate and provided the initial configuration to contact FortiManager.
C. FortiGAte has obtained a configuration from the platform template in FortiGate cloud.
D. A factory reset performed on FortiGate.
E. The zero-touch provisioning process has completed internally, behind FortiGate.

Correct Answer: AE

QUESTION 17
Which two statements reflect the benefits of implementing the ADVPN solution to replace conventional VPN topologies? (Choose two.)

A. It creates redundant tunnels between hub-and-spokes, in case failure takes place on the primary links.
B. It dynamically assigns cost and weight between the hub and the spokes, based on the physical

distance.
C. It ensures that spoke-to-spoke traffic no longer needs to flow through the tunnels through the hub.
D. It provides direct connectivity between all sites by creating on-demand tunnels between spokes.

Correct Answer: CD

QUESTION 18
Refer to the exhibit.

Based on output shown in the exhibit, which two commands can be used by SD-WAN rules? (Choose two.)

A. set cost 15.
B. set source 100.64.1.1.
C. set priority 10.
D. set load-balance-mode source-ip-based.

Correct Answer: CD

QUESTION 19
Refer to the exhibit.

Which two statements about the debug output are correct? (Choose two.)

A. The debug output shows per-IP shaper values and real-time readings.
B. This traffic shaper drops traffic that exceeds the set limits.
C. Traffic being controlled by the traffic shaper is under 1 Kbps.
D. FortiGate provides statistics and reading based on historical traffic logs.

Correct Answer: AB

QUESTION 20
In the default SD-WAN minimum configuration, which two statements are correct when traffic matches the default implicit SD-WAN rule? (Choose two.)

A. Traffic has matched none of the FortiGate policy routes.
B. Matched traffic failed RPF and was caught by the rule.
C. The FIB lookup resolved interface was the SD-WAN interface.
D. An absolute SD-WAN rule was defined and matched traffic.

Correct Answer: AC

QUESTION 21
Refer to the exhibit.

Which statement about the trace evaluation by FortiGate is true?
A. Packets exceeding the configured maximum concurrent connection limit are denied by the per-IP shaper.
B. The packet exceeded the configured bandwidth and was dropped based on the priority configuration.
C. The packet exceeded the configured maximum bandwidth and was dropped by the shared shaper.
D. Packets exceeding the configured concurrent connection limit are dropped based on the priority configuration.

Correct Answer: A

QUESTION 22
Refer to the exhibit.

FortiGate has multiple dial-up VPN interfaces incoming on port1 that match only FIRST_VPN.

Which two configuration changes must be made to both IPsec VPN interfaces to allow incoming connections to match all possible IPsec dial-up interfaces? (Choose two.)

A. Specify a unique peer ID for each dial-up VPN interface.
B. Use different proposals are used between the interfaces.
C. Configure the IKE mode to be aggressive mode.
D. Use unique Diffie Hellman groups on each VPN interface.

Correct Answer: BD

QUESTION 23
Refer to exhibits.


Exhibit A shows the firewall policy and exhibit B shows the traffic shaping policy.

The traffic shaping policy is being applied to all outbound traffic; however, inbound traffic is not being evaluated by the shaping policy.

Based on the exhibits, what configuration change must be made in which policy so that traffic shaping can be applied to inbound traffic?

A. The guaranteed-10mbps option must be selected as the per-IP shaper option.
B. The guaranteed-10mbps option must be selected as the reverse shaper option.
C. A new firewall policy must be created and SD-WAN must be selected as the incoming interface.
D. The reverse shaper option must be enabled and a traffic shaper must be selected.

Correct Answer: B

QUESTION 24
Refer to the exhibit.

What must you configure to enable ADVPN?

A. ADVPN should only be enabled on unmanaged FortiGate devices.
B. Each VPN device has a unique pre-shared key configured separately on phase one.
C. The protected subnets should be set to address object to all (0.0.0.0/0).
D. On the hub VPN, only the device needs additional phase one settings.

Correct Answer: B

QUESTION 25
Which two statements describe how IPsec phase 1 main mode id different from aggressive mode when performing IKE negotiation? (Choose two.)

A. A peer ID is included in the first packet from the initiator, along with suggested security policies.
B. XAuth is enabled as an additional level of authentication, which requires a username and password.
C. A total of six packets are exchanged between an initiator and a responder instead of three packets.
D. The use of Diffie Hellman keys is limited by the responder and needs initiator acceptance.

Correct Answer: BC

QUESTION 26
What are two benefits of using FortiManager to organize and manage the network for a group of FortiGate devices? (Choose two.)

A. It simplifies the deployment and administration of SD-WAN on managed FortiGate devices.
B. It improves SD-WAN performance on the managed FortiGate devices.
C. It sends probe signals as health checks to the beacon servers on behalf of FortiGate.
D. It acts as a policy compliance entity to review all managed FortiGate devices.
E. It reduces WAN usage on FortiGate devices by acting as a local FortiGuard server.

Correct Answer: AD

QUESTION 27
What would best describe the SD-WAN traffic shaping mode that bases itself on a percentage of available
bandwidth?

A. Per-IP shaping mode
B. Shared policy shaping mode
C. Interface-based shaping mode
D. Reverse policy shaping mode

Correct Answer: B


Resources From:

1.2021 Latest Braindump2go NSE7_SDW-6.4 Exam Dumps (PDF & VCE) Free Share:
https://www.braindump2go.com/nse7-sdw-6-4.html

2.2021 Latest Braindump2go NSE7_SDW-6.4 PDF and NSE7_SDW-6.4 VCE Dumps Free Share:
https://drive.google.com/drive/folders/1ZF64HYe3ZFxcWI0ZQMeUB0F-CvAjFBqg?usp=sharing

3.2021 Free Braindump2go NSE7_SDW-6.4 Exam Questions Download:
https://www.braindump2go.com/free-online-pdf/NSE7_SDW-6.4-PDF-Dumps(12-27).pdf
https://www.braindump2go.com/free-online-pdf/NSE7_SDW-6.4-VCE-Dumps(1-11).pdf

Free Resources from Braindump2go,We Devoted to Helping You 100% Pass All Exams!