CISCO OFFICIAL: 640-911 Exam Questions has been Updated Today! Free Download the Latest 640-911 Dumps PDF and 640-911 Exam VCE Now!
2015 Timesaving Comprehensive Guides For Cisco 640-911 Exam: Using Latst Released Braindump2go 640-911 Practice Tests Questions, Quickly Pass 640-911 Exam 100%! Following Questions and Answers are all the New Published By Cisco Official Exam Center!
Exam Code: 640-911
Exam Name: Introducing Cisco Data Center Networking (DCICN)
Keywords: 640-911 Exam Dumps,640-911 Practice Tests,640-911 Practice Exams,640-911 Exam Questions,640-911 PDF,640-911 VCE Free,640-911 Book,640-911 E-Book,640-911 Study Guide,640-911 Braindump,640-911 Prep Guide
Cisco 640-911 Dumps VCE&PDF Download: http://www.braindump2go.com/640-911.html
An engineer replaces multiple hubs in the network with Layer 2 switches. What are two effects on the performance of the network? (Choose two.)
A. reduced number of frame collisions
B. multiple devices can transmit and receive frames simultaneously
C. reduced broadcast packet propagation
D. reduced complexity in monitoring traffic within the Layer 2 domain
E. reduced number of packet collisions
Refer to the exhibit. If switch SW2 was replaced with a router, which two effects would it have on the network? (Choose two.)
A. reduce the number of collision domains
B. increase the number of broadcast domains
C. increase the number of collision domains
D. reduce the number of broadcast domains
E. no change in collision domains
A network engineer has multiple network devices to choose from to connect 10 PCs to a network. Requirements include that packet collisions are minimized for each client and that the physical network topology must be highly scalable. Which two connectivity options should the engineer use? (Choose two.)
A. Connect each of the 10 client PCs to a network switch.
B. Use a star physical network topology.
C. Connect each of the 10 client PCs to a network router.
D. Connect each of the 10 client PCs to a network hub.
E. Use a ring physical network topology.
F. Use a mesh physical network topology.
Which protocol operates at Layer 3 of OSI model and is used for host addressing?
After a firewall is installed in the network, users have lost FTP access to the remote Cisco Nexus switches, but the TFTP access still works. Which protocol is blocked by the firewall?
A network operations team needs to monitor the health of Cisco Nexus switches. Which type of UDP-based protocol should be configured on these devices for management and monitoring?
Which protocol is supported when OSPFv2 is used as the routing protocol?
What is the maximum distance for 100Base-TX?
What is the result when two data transmissions are sent at the same time?
A. A collision occurs and both devices stop transmission and back off.
B. A collision occurs and one device retransmits.
C. All traffic continues to transmit.
D. A collision occurs and both devices resend transmissions.
There is a large amount of traffic inside a network segment with a destination address of
FF:FF:FF:FF:FF:FF. What type of traffic uses this address?
A. FF:FF:FF:FF:FF:FF is the Layer 2 broadcast address.
B. FF:FF:FF:FF:FF:FF is the Layer 2 network address.
C. FF:FF:FF:FF:FF:FF is the Layer 3 broadcast address.
D. FF:FF:FF:FF:FF:FF is the Layer 3 network address.
E. FF:FF:FF:FF:FF:FF is multicast traffic.
What two commands are used to modify the MAC Table? (Choose two.)
A. no mac-address-table static
B. show address-table
C. mac-address-table aging
D. show mac-address-table
E. address-table static
Braindump2go New Released 640-911 Dumps PDF are Now For Free Download, 185 Latest Questions, Download It Right Now and Pass Your Exam 100%:
|One Time Purchase||✔||✖||✖||✖||✖|
|100% Pass Guarantee||✔||✖||✖||✖||✖|
|100% Money Back||✔||✖||✖||✖||✖|